Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
NOT supported error happens when a command is incompatible with the current GT version. The manual's first action is: “Upgrade the version of the GT, or use another command.”
Parameter error indicates the specified parameter does not exist or cannot be used. The manual's first action is: “The specified parameter does not exist, or it cannot be used.”
Time up error or response error occurs if there’s no reply from PLC, possibly due to cable disconnection or noise interference. The manual's first action is: “1) PLC connection cable is disconnected. Check the wiring …
Response error occurred because an abnormal response was returned from an external device. The manual's first action is: “Check the data to be returned from the external device.”
Numerical data error happens when the designated read/write area is incorrectly specified. The manual's first action is: “Verify whether or not the reference device used with the basic communication area and each part…
Overrun error occurs when the GT cannot receive data from the PLC, possibly due to PLC runaway. The manual's first action is: “PLC runaway might be the problem.”
Data error occurred during communication with the PLC. The manual's first action is: “Check for errors in the communication conditions settings.”
Cannot be executed due to operation mode because the PLC received a command incompatible with its current operating mode. The manual's first action is: “Change the mode of the PLC from the operation mode to the monito…
Numerical data error occurs when the designated read/write area is incorrectly specified. The manual's first action is: “Verify whether or not the reference device used with the basic communication area and each part …
Cannot be executed due to operation mode because the PLC received an incompatible command or invalid format in current mode. The manual's first action is: “Change the mode of the PLC from the operation mode to the mon…
Time up error happens if the PLC connection cable is disconnected or due to noise interference, possibly with incorrect BCC value. The manual's first action is: “Check the wiring of the connection cable and check for …
NAK error is returned from the PLC, indicating a rejection of a command or request. The manual's first action is: “Verify the PLC settings.”
Overrun error occurs because the GT cannot receive data from the PLC. The manual's first action is: “PLC runaway might be the problem.”
Data error occurred during communication with the PLC. The manual's first action is: “Check for errors in the communication conditions settings.”
Data run error happens when an invalid register or relay number is used during GTWIN screen creation. The manual's first action is: “Correct the output device being used with the part, or the transfer of clock data to…