Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Hardware fault code 0x0001 indicates a detected hardware issue. The manual lists no action for this code.
Error code 43 or higher indicates an error state. The manual's first action is: “press the [Clear Error Log] button in the "Status Display" dialog box”
All 77 error codes of the Panasonic FP0H Panasonic FP0H with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
SATA Cabling Error indicates one or more SATA devices are improperly attached. The manual's first action is: “Ensure SATA connectors are used in ascending order. For one device, use SATA 0. For two devices, use SATA 0…
The computer cover has been removed since the last startup. The manual's first action is: “N/A”
Chassis, rear chassis, or front chassis fan is not detected. The manual's first action is: “1. Reseat chassis, rear chassis, or front chassis fan. 2. Reseat fan cable. 3. Replace chassis, rear chassis, or front chassi…
The system detected that the CPU fan is not connected or has malfunctioned. The manual's first action is: “1. Reseat CPU fan. 2. Reseat fan cable. 3. Replace CPU fan.”
The system detected a keyboard or system unit error. The manual's first action is: “1. Reconnect the keyboard with computer turned off. 2. Ensure that none of the keys are depressed. 3. Replace the keyboard. 4. Replac…
The system detected a keyboard failure. The manual's first action is: “1. Reconnect keyboard with computer turned off. 2. Check connector for bent or missing pins. 3. Ensure that none of the keys are depressed. 4. Rep…
The system has detected a wireless module installed that is not supported and has been disabled. The manual's first action is: “Replace with a supported module.”
A system BIOS recovery has occurred. The manual's first action is: “Not applicable.”
More than one USB type-C card is installed. The manual's first action is: “Remove USB type-C card so only one is installed.”
USB Type-C I2C Not Connected error indicates a missing cable between I2C on card and USB-C on the system board. The manual's first action is: “Install cable between I2C on card and USB-C on the system board.”
A PCIe device failed to initialize due to incompatibility or configuration issues. The manual's first action is: “Try rebooting the system. If the error reoccurs, the device may not work with this system.”
The front USB1/USB2 port is not connected due to a detached cable. The manual's first action is: “Reconnector or replace front USB cable.”