Ningbo Anson Hi Series Error Er048: CD.00 (DC link controller setting value is wrong.)

Servo drive · taken from the manufacturer’s manual, pages cited

Error codeEr048

CD.00 (DC link controller setting value) is wrong when CD.00 must be bigger than PU.17 (Brake voltage). The manual's first action is: “Adjust CD.00 value”

Model
Ningbo Anson Hi Series
Display shows
CD.00 (DC link controller setting value is wrong.) (Er048)
Type
Error code
Source
Manual p. 86

What Er048 means

CD.00 (DC link controller setting value is wrong.) p. 86

Common causes

  • CD.00 must be bigger than PU.17 (Brake voltage). p. 86

What to do

  1. Adjust CD.00 value p. 86

If Er048 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.

Open the manual at page 86 All Hi Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er048; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.