Mitsubishi Electric MDS-C1 Series Error 46: Motor overheat

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code46

Motor overheat alarms when motor or detector temperature protection activates, either before or after operation starts. The manual's first action is: “NR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Motor overheat (46)
Type
Error code
Source
Manual p. 311

What 46 means

Motor overheat p. 311

Common causes

  • The temperature protection function in the motor or detector activated. p. 311
  • The alarm occurs before operation. p. 311
  • The alarm occurs occasionally after operation is started. p. 311
  • The connector is disconnected (or loose). p. 311
  • The connector is not disconnected. p. 311
  • The cable is broken. p. 311
  • The cable is not broken. p. 311

What to do

  1. NR p. 311
  2. Investigate item 2. p. 311
  3. Investigate item 5. p. 311
  4. Correctly install. p. 311
  5. Investigate item 3. p. 311
  6. Replace the cable. p. 311
  7. Servo : Investigate item 4. Spindle : Investigate item 12. p. 311

Before you service the product, read the safety instructions in the manual p. 4.

If 46 is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 46; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.