Mitsubishi Electric MDS-C1 Series Error 50: Overload 1

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code50

Overload 1 happens when motor or drive unit exceeds 100% overload detection level, regardless of whether standard values are set or not. The manual's first action is: “NR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Overload 1 (50)
Type
Error code
Source
Manual p. 311

What 50 means

Overload 1 p. 311

Common causes

  • The overload detection level reached 100% or more. The motor or drive unit is in the overload state. p. 311
  • The standard values (below) are not set. p. 311
  • The standard values are set. p. 311
  • The load is large. p. 311
  • Resonance is occurring. p. 311
  • Resonance is not occurring. p. 311
  • The motor is hunting. p. 311
  • The motor is not hunting. p. 311
  • The motor brakes are not released. p. 311
  • The motor brake operation is normal. p. 311
  • The cutting load is large. p. 311
  • There is interference with the positioning pin. p. 311
  • An excessive force is applied from the machine. p. 311
  • The machine load is not large. p. 311
  • There is a problem. p. 311
  • Normal p. 311
  • The motor performance is in sufficient. p. 311
  • The motor performance is sufficient. p. 311
  • Improved. p. 311
  • Not improved. p. 311

What to do

  1. NR p. 311
  2. Set the standard values. p. 311
  3. Investigate item 2. p. 311
  4. Investigate item 9. p. 311
  5. Adjust the parameters. • Set the notch filter. • Lower VGN1 (SV005). p. 311
  6. Investigate item 4. p. 311
  7. Adjust the parameters. • Increase VGN1 (SV005). • Lower VIA (SV008). p. 311
  8. Investigate item 5. p. 311
  9. Correct the faulty section. p. 311
  10. Investigate item 6. p. 311
  11. Lower the cutting load. p. 311
  12. When using the positioning pin, turn the servo OFF when stopped. p. 311
  13. Check whether the ball screw is bent, or whether there is a fault in the guide. p. 311
  14. Investigate item 8. p. 311
  15. Adjust the PLG output waveform. p. 311
  16. Lower the acceleration/deceleration rate or cutting load. p. 311
  17. Replace the drive unit. p. 311
  18. Replace the motor. p. 311

Before you service the product, read the safety instructions in the manual p. 4.

If 50 is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 50; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.