Mitsubishi Electric MDS-C1 Series Error 3F: Speed excessive deflection 2

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code3F

Speed excessive deflection 2 happens during constant speed operation when the difference between command and feedback speed exceeds set limits due to heavy cutting load. The manual's first action is: “PR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Speed excessive deflection 2 (3F)
Type
Error code
Source
Manual p. 310

What 3F means

Speed excessive deflection 2 p. 310

Common causes

  • During constant speed operation, the difference between the speed command and speed feedback exceeded the set amount and set time. p. 310
  • The cutting load is large. p. 310
  • The cutting load is not large. p. 310
  • Not improved. p. 310

What to do

  1. PR p. 310
  2. Lower the cutting load. p. 310
  3. Investigate item 2. p. 310
  4. Replace the drive unit. p. 310

Before you service the product, read the safety instructions in the manual p. 4.

If 3F is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 3F; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.