Mitsubishi Electric MDS-C1 Series Error 51: Overload 2

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code51

Overload 2 occurs when servo current exceeds 95% for one second or spindle load exceeds continuous rating for 30 minutes during operation. The manual's first action is: “NR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Overload 2 (51)
Type
Error code
Source
Manual p. 311

What 51 means

Overload 2 p. 311

Common causes

  • With the servo, a current command exceeding 95% of the unit's maximum current continued for one second or more. With the spindle, a load exceeding the continuous rating continued for 30 minutes or more. p. 311
  • The alarm occurred after ready ON before operation starts. p. 311
  • The alarm occurred after normal operation. p. 311

What to do

  1. NR p. 311
  2. Investigate item 2. p. 311
  3. Investigate item 5. p. 311

Before you service the product, read the safety instructions in the manual p. 4.

If 51 is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 51; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.