Mitsubishi Electric MDS-C1 Series Error 40: Detector changeover unit, changeover error

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code40

Detector changeover unit, changeover error occurs when motor changeover signals from the detector unit are faulty or disconnected. The manual's first action is: “PR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Detector changeover unit, changeover error (40)
Type
Error code
Source
Manual p. 311

What 40 means

Detector changeover unit, changeover error p. 311

Common causes

  • During 1-drive unit 2-motor control, an error was detected in the motor changeover signal received form the detector changeover unit. p. 311
  • The connector is disconnected (or loose). p. 311
  • The connector is not disconnected. p. 311
  • The cable is broken. p. 311
  • The cable is not broken. p. 311
  • No abnormality was found in particular. p. 311

What to do

  1. PR p. 311
  2. Correctly install. p. 311
  3. Investigate item 2. p. 311
  4. Replace the cable. p. 311
  5. Investigate item 3. p. 311
  6. Replace the drive unit. p. 311

Before you service the product, read the safety instructions in the manual p. 4.

If 40 is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 40; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.