Mitsubishi Electric MDS-C1 Series Error 4E: NC command mode error

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code4E

NC command mode error occurs when an invalid spindle control mode selection is made, causing consistent or irregular alarms. The manual's first action is: “NR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
NC command mode error (4E)
Type
Error code
Source
Manual p. 311

What 4E means

NC command mode error p. 311

Common causes

  • A spindle control mode selection exceeding the specifications was input. p. 311
  • The alarm always occurs at the same position. p. 311
  • The alarm occurs irregularly. p. 311
  • The alarm occurs during position control. p. 311
  • The alarm occurs during speed control. p. 311

What to do

  1. NR p. 311
  2. Check the NC and PLC program process. p. 311
  3. Investigate item 2. p. 311
  4. Check the NC and PLC program process. (If the cause cannot be pinpointed, replace the drive unit, and confirm.) p. 311

Before you service the product, read the safety instructions in the manual p. 4.

If 4E is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 4E; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.