Mitsubishi Electric MDS-C1 Series Error 3E: Spindle speed overrun

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code3E

Spindle speed overrun occurs when the motor’s feedback speed exceeds the commanded speed or accelerates unexpectedly, even if stopped. The manual's first action is: “PR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Spindle speed overrun (3E)
Type
Error code
Source
Manual p. 310

What 3E means

Spindle speed overrun p. 310

Common causes

  • 1. A state in which the motor's speed feedback exceeded the speed command and accelerated was detected. 2. Even though the speed command is 0 (including when stopped during position control), motor rotation exceeding the parameter setting value was detected. p. 310

What to do

  1. PR p. 310

Before you service the product, read the safety instructions in the manual p. 4.

If 3E is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 3E; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.