FAGOR MAN REGUL (IN) Error 608: Direct feedback signal A and/or B too weak.

Error code608

Direct feedback signals A and/or B too weak due to defective cabling, feedback device, or feedback board (X4/X3), or low parameter values RP1-RP4. The manual's first action is: “Check the cable, the feedback device, the cards or increase the value of these parameters.”

Model: FAGOR MAN REGUL (IN)
Display shows: Direct feedback signal A and/or B too weak. (608)
Type: Error code
Source: Manual p. 332

Meaning
Common causes
What to do
Still not solved
Source

What 608 means

Direct feedback signal A and/or B too weak. p. 332

Common causes

- Defective cabling, feedback device or feedback board (connector X4 or X3). - The value of parameter RP1, RP2, RP3, or RP4 is too low. p. 332

What to do

Check the cable, the feedback device, the cards or increase the value of these parameters. p. 332

If 608 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.

Open the manual at page 332 All MAN REGUL (IN) error codes Manual details & download

This page summarises what the manufacturer’s manual says about 608; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.