FAGOR MAN REGUL (IN) Error 602: Motor feedback B signal saturated.

FAGOR MAN REGUL (IN) servo-drive system · taken from the manufacturer’s manual, pages cited

Error code602

The motor feedback B signal is saturated due to defective cabling or incorrect parameter settings. The manual's first action is: “Check the cable of the Encoder and that of the X4 card or increase the value of these parameters.”

Model
FAGOR MAN REGUL (IN)
Display shows
Motor feedback B signal saturated. (602)
Type
Error code
Source
Manual p. 332

What 602 means

Motor feedback B signal saturated. p. 332

Common causes

  • - Defective rotor sensor cabling, encoder or X4 card. RP1 (gain of the sine signal of the rotor sensor) or RP3 (offset of the sine signal of the rotor sensor) is too large. p. 332

What to do

  1. Check the cable of the Encoder and that of the X4 card or increase the value of these parameters. p. 332

If 602 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.

Open the manual at page 332 All MAN REGUL (IN) error codes Manual details & download

This page summarises what the manufacturer’s manual says about 602; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.