Error code606
Excessive rotor sensor signal drift caused by degraded signal quality, faulty wiring, encoder, X4 card, or ground connection. The manual's first action is: “Check the state of the cable, of the Encoder or of the X4 card, or the ground connections.”
- Model
- FAGOR MAN REGUL (IN)
- Display shows
- Excessive rotor sensor signal drift. (606)
- Type
- Error code
- Source
- Manual p. 332
What 606 means
Excessive rotor sensor signal drift. p. 332
Common causes
- - The quality of the signals has dropped. Wiring of the rotor sensor faulty, Encoder faulty, X4 card faulty or ground connection faulty. p. 332
What to do
- Check the state of the cable, of the Encoder or of the X4 card, or the ground connections. p. 332
If 606 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.
This page summarises what the manufacturer’s manual says about 606; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.