FAGOR MAN REGUL (IN) Error 504: Wrong parameter in SERCOS stage two.

FAGOR MAN REGUL (IN) servo-drive system · taken from the manufacturer’s manual, pages cited

Error code504

An incorrect parameter is configured in the SERCOS stage two protocol. The manual's first action is: “Correct the parameter.”

Model
FAGOR MAN REGUL (IN)
Display shows
Wrong parameter in SERCOS stage two. (504)
Type
Error code
Source
Manual p. 331

What 504 means

Wrong parameter in SERCOS stage two. p. 331

Common causes

  • - Only with Sercos interface: parameter QV21 -S21- contains the wrong parameter list corresponding to stepping to stage two of the Sercos protocol. For now, it can only be seen by means of the ddsetup.exe on DOS. p. 331

What to do

  1. Correct the parameter. p. 331

If 504 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.

Open the manual at page 331 All MAN REGUL (IN) error codes Manual details & download

This page summarises what the manufacturer’s manual says about 504; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.