Danfoss 100 FLOW Error 78: ID 1078 - Identification Ongoing

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault code78

ID 1078 - Identification Ongoing means the drive is running identification for the motor. The manual's first action is: “You can stop the identification run at any time by removing the start command. When the identification run is completed, a new start command is needed to start the drive.”

Model
Danfoss 100 FLOW
Display shows
ID 1078 - Identification Ongoing (78)
Type
Fault code
Source
Manual p. 315

What 78 means

ID 1078 - Identification Ongoing p. 315

Common causes

  • The drive is running the identification for the motor. p. 315

What to do

  1. You can stop the identification run at any time by removing the start command. When the identification run is completed, a new start command is needed to start the drive. p. 315

If 78 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 315 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about 78; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.