Danfoss 100 FLOW Error 70: BaselineRun Failed

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault code70

BaselineRun Failed occurs when there was a failure during baseline run, requiring checking baseline run settings. The manual's first action is: “Do a check of the parameters in the baseline run settings.”

Model
Danfoss 100 FLOW
Display shows
BaselineRun Failed (70)
Type
Fault code
Source
Manual p. 313

What 70 means

BaselineRun Failed p. 313

Common causes

  • There was a failure during the baseline run. p. 313

What to do

  1. Do a check of the parameters in the baseline run settings. p. 313

If 70 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 313 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about 70; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.