Danfoss 100 FLOW Error 76: Start Prevented

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault code76

Start Prevented occurs to block start command during first power-up to prevent accidental rotation. The manual lists no action for this code.

Model
Danfoss 100 FLOW
Display shows
Start Prevented (76)
Type
Fault code
Source
Manual p. 314

What 76 means

Start Prevented p. 314

Common causes

  • The start command is blocked to prevent the accidental rotation of the motor during the first power-up. p. 314

If 76 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 314 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about 76; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.