Danfoss 100 FLOW Error 69: Fieldbus Mapping Error

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault code69

Fieldbus Mapping Error occurs if ID numbers for Fieldbus Process Data Out are invalid or types undefined, requiring checking parameters in Fieldbus Data menu. The manual's first action is: “Check the parameters in the Fieldbus Data menu.”

Model
Danfoss 100 FLOW
Display shows
Fieldbus Mapping Error (69)
Type
Fault code
Source
Manual p. 313

What 69 means

Fieldbus Mapping Error p. 313

Common causes

  • The ID number that is used to map the values to Fieldbus Process Data Out is not valid. p. 313
  • It is not possible to convert 1 or more values for Fieldbus Process Data Out. p. 313
  • The type of the value is undefined. p. 313
  • There is an overflow when the values for Fieldbus Process Data Out (16-bit) are mapped and converted. p. 313

What to do

  1. Check the parameters in the Fieldbus Data menu. p. 313

If 69 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 313 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about 69; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.