Danfoss 100 FLOW Error 63: Quick Stop Fault

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault code63

Quick Stop Fault occurs when the quick stop function is activated, requiring finding and correcting the cause. The manual's first action is: “Find the cause for the quick stop activation. After you find it, correct it. Reset the fault and restart the drive.”

Model
Danfoss 100 FLOW
Display shows
Quick Stop Fault (63)
Type
Fault code
Source
Manual p. 311

What 63 means

Quick Stop Fault p. 311

Common causes

  • The quick stop function is activated. p. 311

What to do

  1. Find the cause for the quick stop activation. After you find it, correct it. Reset the fault and restart the drive. p. 311
  2. See parameter P3.5.1.26 and the quick stop parameters. p. 311

If 63 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 311 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about 63; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.