Error code#1307
One or more dimensions of the H-beam are too small or negative, or a Weight value is missing in Weighted Average mode. The manual's first action is: “Fix the error then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- ONE OR MORE OF THE H-BEAM DIMENSIONS IS TOO SMALL. (#1307)
- Type
- Error code
- Source
- Manual p. 436
What #1307 means
ONE OR MORE OF THE H-BEAM DIMENSIONS IS TOO SMALL. p. 436
Common causes
- One of the H-beam parameters, namely, the width, height, or the length is either too small or has a negative value. p. 436
- If the Weighted Average mode was selected, the Weight value must be indicated in the table. p. 436
What to do
- Fix the error then try again. p. 436
Before you service the product, read the safety instructions in the manual p. 526.
If #1307 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #1307; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.