The value assigned to the orientation parameter in the L-beam template is invalid. The manual's first action is: “Make sure that the proper value is used to define the orientation parameter, then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- INVALID PARAMETER VALUE FOR L-BEAM TEMPLATE ORIENTATION. (#1252)
- Type
- Error code
- Source
- Manual p. 434
What #1252 means
INVALID PARAMETER VALUE FOR L-BEAM TEMPLATE ORIENTATION. p. 434
Common causes
- The 'L-beam' template can be defined using any one of four different orientations, depending on the sample geometry. The error message means that the orientation parameter value is invalid. p. 434
What to do
- Make sure that the proper value is used to define the orientation parameter, then try again. p. 434
Before you service the product, read the safety instructions in the manual p. 526.
If #1252 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #1252; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.