Canberra 9233653E V3.0 Error #1305: H-BEAM CROSS-BAR IS TOO THICK.

Genie™ 2000 Spectroscopy Software · taken from the manufacturer’s manual, pages cited

Error code#1305

The cross-bar thickness of the H-beam exceeds its outside height. The manual's first action is: “Change the cross-bar thickness to fix the error. Then try again.”

Model
Canberra 9233653E V3.0
Display shows
H-BEAM CROSS-BAR IS TOO THICK. (#1305)
Type
Error code
Source
Manual p. 436

What #1305 means

H-BEAM CROSS-BAR IS TOO THICK. p. 436

Common causes

  • The thickness of the H-beam cross-bar thickness is greater than the outside height of the beam. p. 436

What to do

  1. Change the cross-bar thickness to fix the error. Then try again. p. 436

Before you service the product, read the safety instructions in the manual p. 526.

If #1305 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.

Open the manual at page 436 All 9233653E V3.0 error codes Manual details & download

This page summarises what the manufacturer’s manual says about #1305; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.