The orientation parameter for the L-beam template is missing in its definition. The manual's first action is: “Insert the orientation parameter in the 'L-beam' template description to fix the error., then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- TEMPLATE ORIENTATION PARAMETER FOR L-BEAM IS MISSING. (#1251)
- Type
- Error code
- Source
- Manual p. 434
What #1251 means
TEMPLATE ORIENTATION PARAMETER FOR L-BEAM IS MISSING. p. 434
Common causes
- The 'L-beam' template can be defined using any one of four different orientations, depending on the sample geometry. The error message means that the orientation parameter value is not found in the description. p. 434
What to do
- Insert the orientation parameter in the 'L-beam' template description to fix the error., then try again. p. 434
Before you service the product, read the safety instructions in the manual p. 526.
If #1251 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #1251; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.