Canberra 9233653E V3.0 Error #1253: SOURCE IS OUT OF L-BEAM.

Genie™ 2000 Spectroscopy Software · taken from the manufacturer’s manual, pages cited

Error code#1253

The source is positioned outside the boundaries of the L-beam template. The manual's first action is: “Fix the error, then try again.”

Model: Canberra 9233653E V3.0
Display shows: SOURCE IS OUT OF L-BEAM. (#1253)
Type: Error code
Source: Manual p. 434

Meaning
Common causes
What to do
Still not solved
Source

What #1253 means

SOURCE IS OUT OF L-BEAM. p. 434

Common causes

The 'L-beam' template description defines both the left and right ends of any source relative to the right end of the beam. The above error message means that the right and/or left end of the source exceeds the length of the beam. p. 434

What to do

Fix the error, then try again. p. 434

Before you service the product, read the safety instructions in the manual p. 526.

If #1253 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.

Open the manual at page 434 All 9233653E V3.0 error codes Manual details & download

This page summarises what the manufacturer’s manual says about #1253; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.