The wall thickness of the rectangular tube has been set too high, as doubling it exceeds either its width or height. The manual's first action is: “Change the wall thickness to fix the error. Then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- THE RECTANGULAR TUBE WALL IS TOO THICK. (#1353)
- Type
- Error code
- Source
- Manual p. 436
What #1353 means
THE RECTANGULAR TUBE WALL IS TOO THICK. p. 436
Common causes
- The wall thickness of the rectangular tube has defined such that if the thickness is doubled, it is greater than either the outside width or the outside height of the tube. p. 436
What to do
- Change the wall thickness to fix the error. Then try again. p. 436
Before you service the product, read the safety instructions in the manual p. 526.
If #1353 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #1353; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.