Canberra 9233653E V3.0 Error #1206: U-CHANNEL SIDE WALL IS TOO THICK.

Genie™ 2000 Spectroscopy Software · taken from the manufacturer’s manual, pages cited

Error code#1206

The side wall thickness of the U-channel exceeds the channel’s outside width. The manual's first action is: “Change the side wall thickness to fix the error, then try again.”

Model
Canberra 9233653E V3.0
Display shows
U-CHANNEL SIDE WALL IS TOO THICK. (#1206)
Type
Error code
Source
Manual p. 434

What #1206 means

U-CHANNEL SIDE WALL IS TOO THICK. p. 434

Common causes

  • The side wall thickness of the U-channel has been defined such that side the thickness is greater than the channel outside width. p. 434

What to do

  1. Change the side wall thickness to fix the error, then try again. p. 434

Before you service the product, read the safety instructions in the manual p. 526.

If #1206 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.

Open the manual at page 434 All 9233653E V3.0 error codes Manual details & download

This page summarises what the manufacturer’s manual says about #1206; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.