Canberra 9233653E V3.0 Error #1204: INVALID LENGTH OF SOURCE IN THE U-CHANNEL TEMPLATE.

Genie™ 2000 Spectroscopy Software · taken from the manufacturer’s manual, pages cited

Error code#1204

The length of the source within the U-channel template exceeds its defined limits. The manual's first action is: “Fix the error, then try again.”

Model
Canberra 9233653E V3.0
Display shows
INVALID LENGTH OF SOURCE IN THE U-CHANNEL TEMPLATE. (#1204)
Type
Error code
Source
Manual p. 434

What #1204 means

INVALID LENGTH OF SOURCE IN THE U-CHANNEL TEMPLATE. p. 434

Common causes

  • The 'U-channel' template description defines both the left and right ends of any source relative to the channel right end. The above error message means that the source right end is farther away from the right end of the channel than the source left end. p. 434

What to do

  1. Fix the error, then try again. p. 434

Before you service the product, read the safety instructions in the manual p. 526.

If #1204 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.

Open the manual at page 434 All 9233653E V3.0 error codes Manual details & download

This page summarises what the manufacturer’s manual says about #1204; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.