Canberra 9233653E V3.0 Error #1153: INVALID LENGTH OF THE INSIDE SOURCE.

Genie™ 2000 Spectroscopy Software · taken from the manufacturer’s manual, pages cited

Error code#1153

The length of the inside source in the round tube template is incorrectly defined. The manual's first action is: “Fix the error, then try again.”

Model
Canberra 9233653E V3.0
Display shows
INVALID LENGTH OF THE INSIDE SOURCE. (#1153)
Type
Error code
Source
Manual p. 432

What #1153 means

INVALID LENGTH OF THE INSIDE SOURCE. p. 432

Common causes

  • The 'round tube' template description defines the inside source length using the distance of the right and left ends of the source relative to the right end of the tube. The above error message means that the inside source right end is farther way from the right end of the tube than the inside source left end. p. 432

What to do

  1. Fix the error, then try again. p. 432

Before you service the product, read the safety instructions in the manual p. 526.

If #1153 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.

Open the manual at page 432 All 9233653E V3.0 error codes Manual details & download

This page summarises what the manufacturer’s manual says about #1153; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.