Industrial

This datasheet provides detailed specifications for the C&D LSN-10A D5 Series SIP non-isolated DC/DC converters. These converters accept a 5V input (4.5V to 5.5V input range) and deliver 1V, 1.2V, 1.5V, 1.8V, 2V, 2.5, 3.3 or 3.8V outputs at 10 Amps.

LMH6654/55 is a single/dual low power, 250MHz, low noise amplifier.

This document introduces the features and characteristics of the SL1002A series of Littelfuse. The series products have ultra-low insertion loss, surface mountability, 5kA surge capacity, and can be used to meet Telcordia GR1089 and other standards.

The TSOP322.. - series are miniaturized receivers for infrared remote control systems.

This datasheet provides detailed information about ADM206E/ADM207E/ADM208E/ADM211E/ADM213E products, including product functions, features, specifications, etc.

The S-808xxC series is a series of high-precision voltage detectors developed using CMOS process.

The DS92LV16 is a transparent translator from a 16-bit parallel bus to a BLVDS serial stream, supporting 25-80MHz frequencies, with independent transmitter and receiver operation, hot plug protection and synchronization

The LTC3714 is a synchronous step-down switching regulator controller for CPU power. An output voltage between 0.6V and 1.75V is selected by a 5-bit code (Intel mobile VID specification). The controller uses a constant on-time, valley current control architecture to deliver very low duty cycles without requiring a sense resistor. Operating frequency is selected by an external resistor and is compensated by a compensation capacitor. The device offers a fast switching rate and is stable in high input voltage ranges. It also features good protection in short circuit conditions.

The document describes a T-1 (3mm) solid-state lamp with features such as low power consumption, reliability, ruggedness, and long life.

The LTC1594/LTC1598 are micropower, 12-bit sampling A/D converters that feature 4- and 8-channel multiplexers, respectively. They typically draw only 320µA of supply current when converting and automatically power down to a typical supply current of 1nA between conversions. The LTC1594 is available in a 16-pin SO package and the LTC1598 is packaged in a 24-pin SSOP. Both operate on a 5V supply. The 12-bit, switched-capacitor, successive approximation ADCs include a sample-and-hold. On-chip serial ports allow efficient data transfer to a wide range of microprocessors and microcontrollers over three or four wires. This, coupled with micropower consumption, makes remote location possible and facilitates transmitting data through isolation barriers. The circuit can be used in ratiometric applications or with an external reference. The high impedance analog inputs and the ability to operate with reduced spans (to 1.5V full scale) allow direct connection to sensors and transducers in many applications, eliminating the need for gain stages.

The LM32 is a digital temperature sensor from National Semiconductor that measures 3 temperature zones and has a single-wire interface compatible with National Semiconductor's SensorPath bus. Sensor-Path data is pulse width encoded, thereby allowing the LM32 to be easily connected to many general purpose micro-controllers. Several National Semiconductor Super I/O prod- ucts include a fully integrated SensorPath master, that when connected to an LM32 can realize a hardware monitor func- tion that includes limit checking for measured values, au- tonomous fan speed control and many other functions. The LM32 measures the temperature of its own die as well as two external devices such as a processor thermal diode or a diode connected transistor. The LM32 can resolve tem- peratures up to 255˚C and down to -256˚C. The operating temperature range of the LM32 is 0˚C to +125˚C. The ad- dress programming pin allows two LM32s to be placed on one SensorPath bus.

The TUSB3200 is a USB Streaming Controller (STC) data manual from Texas Instruments.

LT2078/LT2079 are low-power dual and quad single supply precision op amps. Its features are low power consumption, large output current, large output swing.

This document describes the features and characteristics of TLV320AIC20, TLV320AIC21, TLV320AIC24, TLV320AIC25, TLV320AIC20K, and TLV320AIC24K products. These products are low-power, highly-integrated, programmable 16-bit, 26KSPS, dual-channel CODECs. They support differential and single-ended analog input/output, stereo 16-bit oversampling sigma-delta A/D converter, and built-in analog functions such as stereo 16-bit oversampling sigma-delta D/A converter, analog and digital sidetone converter, anti-aliasing filter (AAF), programmable input and output gain (PGA), microphone/handset/headset amplifiers, etc. These products also feature selectable FIR/IIR filter, programmable sampling rate, and on-chip FIR, providing 84dB SNR for ADC and 92dB SNR for DAC over 13kHz bandwidth. They are fully compatible with common TMS320® DSP and microcontroller, and support smart time division multiplexed (SMARTDM®) serial port and internally generated master/slave device addresses.