Industrial

This datasheet mainly introduces the characteristics of MA2SV02 variable capacitance diodes

M66850J/FP,M66851J/FP,M66852J/FP,M66853J/FP are high-speed synchronous FIFO(First-In,First-Out) memories fabricated by high-speed CMOS technology. These FIFOs are applicable for a data buffer as networks and communications.

This document provides detailed information on the MtronPTI M5R series 9x14mm, 3.3 Volt, LVPECL/LVDS, clock oscillator.

200pin DDR SDRAM SODIMM M470L1714BT0 is a high density memory module based on 128Mb DDR SDRAM first gen.

This PDF document is the instruction manual of 3D glasses CECH-ZEG1G.

This document describes the features of Mitsubishi Microcomputers' 7470/7471 series microcontrollers. They are designed with CMOS silicon gate technology and are suitable for business equipment and consumer applications. These microcontrollers have a simple instruction set and the same memory map for easy programming.

M34D64 M34D32 64/32 Kbit Serial I²C Bus EEPROM With Hardware Write Control on Top Quarter of Memory is electrically erasable programmable memory (EEPROM) manufactured by STMicroelectronics. It works with a voltage of 4.5V to 5.5V, supports I2C extended addressing, two-wire I2C serial interface, 400 kHz protocol. It has BYTE and PAGE WRITE (up to 32 Bytes), RANDOM and SEQUENTIAL READ modes, self-timed programming cycle, automatic address incrementing, enhanced ESD/Latch-Up behavior, more than 1 million erase/write cycles, more than 40 years data retention time.

This document introduces a 32 Mbit 3V supply flash memory product, which has the characteristics of wide power supply voltage range, short access time, fast programming time, and common flash interface.

The M27V402 is a 4Mbit low voltage UV EPROM and OTP EPROM, with low voltage read operation, fast access time, low power consumption, programming voltage and programming time.

The M27C1024 is a 1 Mbit EPROM offered in the two ranges UV (ultra violet erase) and OTP (one time programmable). It is ideally suited for micro-processor systems requiring large data or program storage and is organized as 65,536 words of 16 bits. The FDIP40W (window ceramic frit-seal package) has a transparent lid which allows the user to expose the chip to ultraviolet light to erase the bit pattern. A new pattern can then be written to the device by following the programming procedure. For application where the content is programmed only one time and erasure is not required, the M27C1024 is offered in PDIP40, PLCC44 and TSOP40 (10 x 14mm) packages.

LTC1798 series micropower bandgap references combine high accuracy and low drift with very low supply current and small package size. The combination of ultralow quiescent current and low dropout voltage of only 200mV (max) makes them ideal for battery-powered equipment. The output voltage is set by an external resistor divider for the adjustable LTC1798. This series of references uses curvature compensation to obtain low temperature coefficient and trimmed thin-film resistors to achieve high output accuracy. These references can source up to 10mA and sink up to 2mA, making them ideal for precision regulator applications. They are stable without an output bypass capacitor, but are also stable with capacitance up to 1µF. This feature is important in critical applications where PC board space is a premium and fast settling is demanded. The LTC1798 series references provided power dissipa- tion advantages over shunt references. In addition to supply current, shunt references must also idle the entire load current to operate. The LTC1798 series is available in the SO-8 package.