Industrial

MN5210 Series is 13µsec, 12-bit Military A/D Converters

This is a Motorola small signal transistor with monolithic bias resistor network, which can reduce system cost and board space.

This document describes the design applications, features, and characteristics of the 5 G D S J210 J211 J212 N-Channel RF Amplifier. It is suitable for HF/VHF mixer/amplifier and applications requiring sufficient gain and low noise for sensitive receivers.

The MM74HC574 is a high-speed octal D-type edge-triggered flip-flop that utilizes advanced silicon-gate P-well CMOS technology. It possesses the high noise immunity and low power consumption of standard CMOS integrated circuits, as well as the ability to drive 15 LS-TTL loads. Due to the large output drive capability and the 3-STATE feature, these devices are ideally suited for interfacing with bus lines in a bus organized system. These devices are positive edge triggered flip-flops. Data at the D inputs, meeting the set-up and hold time requirements, are transferred to the Q outputs on positive going transitions of the CLOCK (CK) input. When a high logic level is applied to the OUTPUT CONTROL (OC) input, all outputs go to a high impedance state, regardless of what signals are present at the other inputs and the state of the storage elements.

This datasheet provides the characteristics, specifications, maximum ratings, and package dimensions for the MLN1037S NPN Silicon RF Power Transistor.

MCR218-6FP / 8FP / 10FP are reverse blocking thyristors designed primarily for half-wave ac control applications, such as motor controls, heating controls and power supply crowbar circuits.

MC9S08RC8/16/32/60 MC9S08RD8/16/32/60 MC9S08RE8/16/32/60 MC9S08RG32/60 Data Sheet

This document describes part number-specific changes to recommended operating conditions and revised electrical specifications, as applicable, from those described in the general MPC7410 Hardware Specifications (Document No. MPC7410EC)

This manual provides detailed information about the MC68LC302 Low Power Integrated Multiprotocol Processor, including its features, instruction set, registers, interfaces, and applications.

The MC3403 is a low-cost, quad operational amplifier with true differential inputs

MC14553B/D 3-digit BCD counter

MBM29LV160TE/BE is a 16Mbit CMOS flash memory chip produced by Fujitsu Semiconductor. It supports 3.0V read, program and erase, is compatible with JEDEC standard commands, uses the same software commands as E2PROMs, is compatible with JEDEC standard world-wide pinouts, and comes in 48-pin TSOP, 48-pin CSOP, and 48-ball FBGA packages. It has 1,000,000 program/erase cycles and a maximum access time of 70ns. It supports sector erase, which allows any combination of sectors to be erased concurrently. It also supports full chip erase.

MBM29F002TC-55/-70/-90/MBM29F002BC-55/-70/-90 is a 2M (256K × 8) BIT CMOS flash memory chip released by Fujitsu Semiconductor. It supports JEDEC-standard commands, is compatible with single-power supply Flash, and has a minimum of 100,000 write/erase cycles and a maximum access time of 55ns