Industrial

The 10ETF.. fast soft recovery QUIETIR rectifier series has been optimized for combined short reverse recovery time and low forward voltage drop.

QTLP670C-2 is a surface mount LED lamp with standard brightness, PLCC-2 package. It features wide viewing angle, water clear optics and moisture-proof packaging. It is ideal for backlighting and optical coupling into light pipes.

The 74LVTH244A is a 3.3V octal buffer/line driver with 3-State outputs. It has TTL input and output switching levels, and input and output interface capability to systems at 5V supply.

This document introduces a semiconductor product, which is a 4M x 32-bit or 8M x 16-bit dynamic RAM module. The module features fast access and cycle time, fast page mode capability, low power dissipation, CAS-before-RAS refresh, etc.

SFH 400, SFH 401 and SFH 402 are GaAs infrared emitters.

This file introduces the features of TC650/TC651, including integrated temperature sensor and multi-speed fan control, built-in over temperature alert(TOVER), temperature proportional fan speed control, pulse width modulation output drive, solid-state temperature sensing, ±1°C(typical) accuracy etc.

BPX 43 is a NPN silicon phototransistor with applications from 450 nm to 1100 nm and high linearity. It is hermetically sealed in a metal package (TO-18) with a base connection and is suitable for 125°C environments. It can be used in photointerrupters and industrial electronics applications.

The BBY 51-03W is a high Q hyperabrupt tuning diode produced by Texas Instruments. It has a maximum reverse voltage of 7 V, a maximum forward current of 20 mA, and a working temperature range of -55°C to 150°C. The storage temperature range is -55°C to 150°C. This diode is mainly used in VCOs in mobile communications equipment.

TC4626/TC4627 are single CMOS high speed drivers with an on-board voltage boost circuit. These parts work with an input supply voltage from 4 to 6 volts. The internal voltage booster will produce a VBOOST potential up to 12 volts above VIN. This VBOOST is not regulated, so its voltage is dependent on the input VDD voltage and output drive loading requirements. An internal undervoltage lockout circuit keeps the output in a low state when VBOOST drops below 7.8 volts. Output is enabled when VBOOST is above 11.3 volts.

This document introduces the features and characteristics of Telcom Semiconductor, Inc.'s TC4426/TC4427/TC4428 1.5A dual high-speed power MOSFET drivers. This series of products has high peak output current, wide operating range, high capacitive load drive capability, short delay time, low supply current, low output impedance, latch-up protection and other features.