Industrial

This manual introduces the use, installation, debugging and maintenance of the CFW-10 series inverters.

This application note shows the test results of the electro static discharge level for MITSUBISHI RF Power Modules RA-series products

This application note shows the reliability concept and reliability level for Silicon RF products.

This application note provides precautions and recommendations for Mitsubishi Electric's Silicon RF Power Semiconductors.

This document introduces the features and characteristics of Mitsubishi Electric's third generation intelligent power modules.

This document describes the features of using Mitsubishi IGBT modules, including their ruggedness, low loss, and ease of use. Advanced processing technologies are utilized to achieve low on-state saturation voltages while maintaining high switching speed for 20kHz operation. The document also explains the structure and operation of IGBT modules and provides a comparison with MOSFET and BJT devices.

This document introduces general application considerations for Mitsubishi H-Series IGBT and intelligent power modules, including power circuit design, snubber design and thermal design.

This document describes the technical specifications and main components of Drivecon Inc.'s Traverse Inverter rev 6.0 with software D2S2V051. It also explains the control modes and control methods.

Drivecon Inc. reserves the right to alter or amend the above information without notice. Before starting, read carefully instructions and this table. Verify all connections are according to drawings. Verify motor supply is connected correctly, wrong connection will destroy the inverter. Verify internal voltage selections of device are correct. Check device cover is properly installed and all ventilation holes are clear and uncovered. Check that hot air coming from brake resistors does not cause any danger. High voltages are present in this device. Do not make any inspections unless the supply has been disconnected by main switch. Before opening the device cover, wait at least 5 minutes after the display lamps turn off. Insulation resistance test with a megger requires special precautions. Do not make any measurements inside the device when it is connected to main supply. Do not touch the IC-circuits on the circuit boards. Static voltage discharge may destroy the components. It is forbidden to use radiophones and portable phones near this device with the doors open. All the doors and covers must be closed during crane in operation.

The document provides detailed information about the product, including the brand, model, features, and characteristics.

The document describes the features and characteristics of a product. The product has specific functions and performance, and is suitable for certain specific application scenarios.