This document describes a SMPS circuit design for LCD monitors or LCD-TVs. The circuit meets global power saving requirements and uses standard thru-hole technology, which can be easily converted to SMT technology.
This document describes the errors that may occur when using an adjustable shunt voltage reference like TL431 in programmable mode and provides a method to calculate the relative error. The document also discusses the impact of inner precision and resistor precision on the overall circuit.
AN1736 is an ST application note that introduces the VIPer22A dual output reference board, which has an input voltage range of 90 to 264 VAC and outputs 5V and 12V at a total output power of 10W.
AN1735 is ST's VIPer22A single output reference board application note, which uses the VIPer22A switch power chip. The input voltage range is 90-264VAC, the output voltage is 12V, the maximum output current is 0.84A, and the maximum output power is 10W.
AN1729 is a technical application note about low cost TV power supply. The application note presents a low cost TV power supply design solution based on the L6565 QR controller, which uses a quasi-resonant flyback converter topology to achieve 1W or less standby power consumption.
This application note describes the TSM108 Evaluation Board. The board can be used for different converter configurations, and is suitable for 12V to 6V DC/DC converters
This paper describes the functionality and the operation of the STSR2P device used as the secondary synchronous rectifier driver in Forward topology switched mode power supplies. The STSR2P Smart Driver IC provides two complementary high current outputs to drive Power Mosfets. The IC is dedicated to properly drive secondary Synchronous Rectifiers in medium power, low output voltage, high efficiency Forward Converters. From a synchronizing clock input, the IC generates two driving signals with a certain dead time between complementary pulses. The adopted transitions...
This document introduces the working principle of TSM1011, including voltage control, current control, power output and power start, and gives detailed calculation formulas.
AN1657 is a Philips application note on power supply design for 17-inch CRT monitors. It introduces the design principle, technical features and application cases of the power supply.
This application note describes the functionality and how the STSR3 device can be used as the secondary synchronous rectifier driver in Flyback topology switched mode power supplies. A schematic and layout description of a demo board that is able to replace diode rectification with synchronous rectification in Flyback converters is shown below.
