TEXAS Manuals

The TPA4411 and TPA4411M are stereo headphone drivers designed to allow the removal of the output DC-blocking capacitors for reduced component count and cost. The TPA4411 and TPA4411M are ideal for small portable electronics where size and cost are critical design parameters.

This is the user's guide of Texas Instruments 1998 Mixed-Signal Products User’s Guide SLOU025.

This document introduces the features of TI's TPA112 model 150mW stereo audio power amplifier, including supply voltage range, power output, gain configuration, thermal protection and short circuit protection.

The TPA112 is a 150mW stereo audio power amplifier from TI, packaged in an 8-pin PowerPAD™ MSOP package, supports 3.3V and 5V power supply, and can output 150mW of continuous RMS power.

The TLC272 and TLC277 precision dual operational amplifiers combine a wide range of input offset voltage grades with low offset voltage drift, high input impedance, low noise, and speeds approaching those of general-purpose BiFET devices. These devices use Texas Instruments silicon-gate LinCMOS technology, which provides offset voltage stability far exceeding the stability available with conventional metal-gate processes. The extremely high input impedance, low bias currents, and high slew rates make these cost-effective devices ideal for applications previously reserved for BiFET and NFET products.

The TLC555 is a monolithic timing circuit fabricated using the TI LinCMOS process. The timer is fully compatible with CMOS, TTL, and MOS logic and operates at frequencies up to 2 MHz. Because of its high input impedance, this device uses smaller timing capacitors than those used by the NE555. As a result, more accurate time delays and oscillations are possible. Power consumption is low across the full range of power supply voltage. Like the NE555, the TLC555 has a trigger level equal to approximately one-third of the supply voltage and a threshold level equal to approximately two-thirds of the supply voltage. These levels can be altered by use of the control voltage terminal (CONT). When the trigger input (TRIG) falls below the trigger level, the flip-flop is set and the output goes high. If TRIG is above the trigger level and the threshold input (THRES) is above the threshold level, the flip-flop is reset and the output goes low.

The TPS6735 is a fixed negative 5-V output inverting dc/dc converter capable of delivering 200 mA from inputs as low as 4.5 V.

This file is tpa6132a2's datasheet, it is a 25mw headphone amplifier, it can connect single ended or differential input, the output power is 2.3v-5.5v, it has acoustic shock prevention function

TPA6140A2 is a Class-G DirectPath™ stereo headphone amplifier with built-in I2C volume control

This is a 50mW stereo audio power amplifier that supports a supply voltage of 3.6V and has low static current and low distortion.

This application report compares two possible blocking or coupling capacitor configurations for stereo headphone amplifiers operating from a single supply voltage. The report demonstrates that the standard two-capacitor configuration can be replaced by a single-capacitor configuration with little or no perceivable difference in sound quality. The primary advantage of a single-capacitor system is that only one large capacitor is required. In many compact multimedia systems like those in personal digital audio players, wireless phones, and personal digital assistants (PDA), these capacitors can be the largest components on the board. Therefore, eliminating one of the bulky coupling capacitors reduces cost and minimizes the area needed on the circuit board.

The OPA627 and OPA637 are a new level of high-performance precision FET operational amplifiers, with lower noise, lower offset voltage, and higher speed. They are widely used in precision and high-speed analog circuitry.

The TPA6111A2 is a stereo audio power amplifier packaged in either an 8-pin SOIC or an 8-pin PowerPAD™ MSOP package capable of delivering 150 mW of continuous RMS power per channel into 16-Ω loads.