TEXAS Manuals

18A, 12V input non-isolated wide-output adjust power module

TI and its subsidiaries reserve the right to make changes to their products or to discontinue any product or service without notice. Customers are advised to obtain the latest version of relevant information to verify the current and complete information before placing orders. TI warrants the performance of its semiconductor products according to the specifications applicable at the time of sale and utilizes testing and quality control techniques to support this warranty.

This datasheet provides the pin definition, package types, power supply, and operating temperature range of SN5400, SN7400, SN54LS00, SN74LS00, SN54S00, and SN74S00.

SN54F244, SN74F244 is an octal buffer/driver with 3-state outputs produced by Texas Instruments. It can drive bus lines or buffer memory address registers. The device is available in plastic small-outline (SOIC) and shrink small-outline (SSOP) packages, ceramic chip carriers, and plastic and ceramic DIPs.

SN54HC02 and SN74HC02 are four independent 2-input positive NOR gates that can operate over the full military temperature range of –55°C to 125°C. The SN54HC02 is characterized for operation from –40°C to 85°C.

This document provides information about the SN74LS597DE4 supplier and packaging. It includes details about the different package types, pin counts, and package quantities of the SN74LS597DE4.

The SN65C3243 and SN75C3243 consist of three line drivers, five line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin-to-pin (serial-port connection pins, including GND). These devices provide the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. In addition, these devices include an always-active noninverting output (ROUT2B), which allows applications using the ring indicator to transmit data while the devices are powered down. The devices operate at data signaling rates up to 1 Mbit/s and an increased slew-rate range of 24 V/µs to 150 V/µs.

The SN75LVDS88B is a TFT LCD panel timing controller with an LVDS interface, suitable for notebook applications, supports XGA resolution, and supports mainstream data and gate drivers.

SN5474,SN54LS74A,SN54S74 SN7474.SN74LS74A,SN74S74 DUAL D-TYPE POSITIVE-EDGE-TRIGGERED FLIP-FLOPS WITH PRESET AND CLEAR

This document describes the features and characteristics of the Harris Semiconductor SCHS205I, including propagation delay, voltage level conversion, operating temperature range, balanced propagation delay, and transition times.

The document describes the features and characteristics of a product called SCBS258M. The product belongs to the Texas Instruments Widebus family and has equivalent 22-Ω series resistors, eliminating the need for external resistors. It supports mixed-mode signal operation with 5V input and output voltages and 3.3V VCC. It also supports unregulated battery operation down to 2.7V. The product has low output ground bounce, Ioff and power-up 3-state support hot insertion, bus hold on data inputs eliminating the need for external pullup/pulldown resistors, distributed VCC and GND pins minimizing high-speed switching noise, flow-through architecture optimizing PCB layout, latch-up performance exceeding 500mA, and ESD protection exceeding 2000V.

The bqTINY series are highly integrated Li-Ion and Li-Pol linear charge management devices targeted at space limited portable applications.

The CD4086B is a 14-lead bipolar CMOS integrated circuit produced by Texas Instruments. It has four 2-input non-gate circuits that can be used for logic operations such as AND, OR, and NOT.

CD54/74AC374, CD54/74AC534, CD54/74ACT374, and CD54ACT534 data sheet.