Thermo Fisher Scientific UV-Retrofit-Kit for MSC Advantage Installation Instructions

Installation instructions for the Thermo Fisher Scientific UV-Retrofit-Kit used on MSC Advantage MSC 1.2 and MSC 1.8 safety cabinets.


Thermo Fisher Scientific UV-Retrofit-Kit for MSC Advantage Installation Instructions - cover page
Brand
Thermo Fisher Scientific
Category
Other
Document type
Installation Guide
Language
English
Pages
22
File format
PDF
File size
1.7 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
2390B1129750487AC6971625B8AAF36F

About this manual

These installation instructions cover fitting the UV-Retrofit-Kit to the Thermo Fisher Scientific MSC Advantage safety cabinet, models MSC 1.2 and MSC 1.8. They cover general safety notes, warranty conditions, symbols, installation safety requirements, applicable standards, required tools and fasteners, and the installation sequence from removing covers through testing the UV lamp.

The kit includes a UVC lamp, ballast unit, lamp sockets, wiring diagrams and wire sets for the MSC 1.2 and MSC 1.8 light boxes, along with mounting hardware and a nameplate. The document also lists the kit components and technical data for the MSC 1.2 and MSC 1.8.

What's inside

  • General notes
  • Safety instructions for service work
  • Applicability of the instructions
  • Warranty
  • Explanation of symbols
  • Safety instructions for installation
  • Standards and safety regulations
  • Tools and fasteners
  • Installing the UV-Retrofit-Kit
  • Components of the UV-Retrofit-Kit

Specifications

Applicable safety cabinet modelsMSC 1.2 and MSC 1.8
UVC lamp power36 W
UVC lamp length826 mm
Ballast unit rating2 X 32 W 120 - 277 V
Lamp socket typeRotating socket for UVC lamp, G5
Mains connectionAC, 230 V - 50-60 Hz
Protection classI
Protection typeIP 20
Cable length3.7 m
Circuit breakerB16 / Fuse T 16 A
Standards and directivesNF 095 Rev3.2006, IEC 61010-1:2002-08, EN 61010-1:2002, EN 12469:2000, DIN EN 61326-1:2008-06, Low Voltage Directive 2006/95/EC, EMV Directive 2004/108/EC

Frequently asked questions

Which safety cabinet models can the UV-Retrofit-Kit be installed on?

The instructions apply to the MSC Advantage safety cabinet models MSC 1.2 and MSC 1.8.

Who should perform repairs and electrical work on the safety cabinet?

Repairs must be carried out only by appropriately qualified personnel, and electrical work only by electrical expert personnel. Defined spare part replacement must be performed by Thermo Fisher Scientific Technical Service or authorized, trained service personnel.

What must be done before installation if the safety cabinet is supplied with gases?

The external gas supply must be shut off prior to installation, the work room must be sufficiently ventilated, and the exhaust system should be activated if equipped.

What should be done before starting the unit after installation?

Any removed or disabled safety devices must be reinstalled and checked for proper operation, and a test run must be performed before startup and operation.

Download PDF (1.7 MB)

More Thermo Fisher Scientific Manuals


View all Thermo Fisher Scientific manuals →