Parker 514C DC Controller Product Manual

Product manual for the Parker 514C DC controller covering installation, commissioning, diagnostics, technical specifications and safety information.


Parker 514C DC Controller Product Manual - cover page
Brand
Parker
Category
Automation control Equipment
Document type
User Manual
Language
English
Pages
44
File format
PDF
File size
1.1 MB
Published
16 November, 2026
Updated
16 November, 2026
Model
514C
MD5 checksum
9EA1C03AB02B91655725BD6274E578E3

About this manual

This product manual covers the Parker 514C DC controller, a single-phase DC motor speed controller designed for industrial environments. It controls the speed of DC shunt wound or permanent magnet motors in all 4 quadrants of operation, operating from a 110 V ac to 415 Vac, 50 or 60 Hz supply. Speed is controlled via a closed loop system using tachogenerator or armature voltage feedback, with a current loop and stall detection for motor protection.

The manual is organized into chapters covering product overview and technical specification, pre-installation planning with wiring diagrams and terminal descriptions, installation procedure, setting-up and commissioning, diagnostics and fault finding, certification, and service and repair. It also includes a terminal comparison for users upgrading from the 540/1 series, which the 514C is designed to be functionally equivalent to.

What's inside

  • Product Overview
  • Pre-Installation Planning
  • Installation Procedure
  • Setting-Up & Commissioning
  • Diagnostics and Fault Finding
  • Certification
  • Service and Repair
  • Technical Specification
  • Terminal Descriptions
  • Product Warnings and Hazards

Specifications

Product range ratings4A, 8A, 16A, 32A DC full load current
Supply voltage110 V ac to 415 Vac at 50 or 60 Hz, single phase
Speed controlClosed loop with proportional integral control; feedback from armature voltage or tachogenerator
100% load regulation2% typical (armature voltage), 0.1% typical (tachogenerator)
Maximum torque/speed range20:1 (armature voltage), 100:1 (tachogenerator)
Speed overload150% for 60 seconds
Torque control accuracy2%
Analogue setpoint input0 to ±10V, 100 Kohm
Tachogenerator input0 to ±350Vdc, 220 Kohm
Thermistor / microtherm input<200 ohm = normal, >1800 ohm = overtemperature
Digital inputsRun, Enable, Stall Override: +10 to +24V, 100 Kohm
Digital outputsHealth, Zero Speed or Setpoint: +24V, 50 mA source
Motor protectionStall detection removes current after approximately 60 seconds; instantaneous overcurrent trip on short circuit

Frequently asked questions

How long should I wait for the drive's capacitors to discharge before working on the equipment?

Allow at least 5 minutes for the drive's capacitors to discharge to safe voltage levels (<50V), and confirm with a meter capable of measuring up to 1000V dc & ac rms.

What type of meter should be used for measurements on the 514C?

Use only a meter to IEC 61010 (CAT III or higher), always starting with the highest range; CAT I and CAT II meters must not be used.

Can the 514C replace a 540 series controller directly?

The 514C is designed to be functionally equivalent to the 540 series controllers, not a direct replacement; the manual includes a terminal-to-terminal comparison of 540/1 to 514C.

What motors is the 514C designed to control?

It is designed to control the speed of DC shunt wound or permanent magnet motors in all 4 quadrants of operation.

Download PDF (1.1 MB)

More Parker Manuals


View all Parker manuals →