provide a detailed technical manual for the 514C DC Controller
The Parker 514C controller is designed for use in industrial environments to control the speed of DC Shunt wound or permanent magnet motors. It operates from a single-phase AC mains supply ranging from 110 Vac to 415 Vac at 50 or 60 Hz. The controller provides speed control in all four quadrants of operation using a linear closed-loop system with feedback from either a tachogenerator or armature voltage.
| Input Voltage Range | 110 Vac to 415 Vac |
|---|---|
| Frequency | 50 or 60 Hz |
| Motor Type | DC Shunt wound or permanent magnet |
| Operation Quadrants | All 4 Quadrants |
| Stall Detection Time | approximately 60 seconds |
Installation, operation and maintenance should be carried out by qualified personnel who are technically competent and familiar with all safety information.
All incoming supplies must be isolated before working on the equipment, and the equipment must be permanently earthed.
At least 5 minutes must be allowed for the drive's capacitors to discharge to safe voltage levels.