Parker 514C Manuals

ManualLib has 3 documents for the Parker 514C (Automation control Equipment): 1 service manual, 2 user manuals. Every file can be read online or downloaded as a PDF for free.

Service Manual 1User Manual 2

Key facts

Brand
Parker
Model
514C
Industry
Industrial
Documents
3
Languages
EN
Last added
2026-11-16

Start here

Parker 514C DC Controller Product Manual

Parker 514C DC Controller Product Manual

User Manual 44 pages · 1.1 MB · EN

This product manual covers the Parker 514C DC controller, a single-phase DC motor speed controller designed for industrial environments. It controls the speed of DC shunt wound or permanent magnet motors in all 4 quadrants of operation, operating from a 110 V ac to 415 Vac, 50 or 60 Hz supply. Speed is controlled via a closed loop system using tachogenerator or armature voltage feedback, with a current loop and stall detection for motor protection.

The manual is organized into chapters covering product overview and technical specification, pre-installation planning with wiring diagrams and terminal descriptions, installation procedure, setting-up and commissioning, diagnostics and fault finding, certification, and service and repair. It also includes a terminal comparison for users upgrading from the 540/1 series, which the 514C is designed to be functionally equivalent to.

Read online

Parker 514C specifications

Product ratings (DC full load current)514C-04: 4A, 514C-08: 8A, 514C-16: 16A, 514C-32: 32A
Main supplySingle phase AC, 110 Vac to 415 Vac, 50 or 60 Hz
Motor typesDC shunt wound or DC permanent magnet motor
Quadrant operationAll 4 quadrants
Speed feedbackTachogenerator or armature voltage, switch selectable
Motor protectionStall detection removes current after approximately 60 seconds
Capacitor discharge timeAllow at least 5 minutes for discharge to safe levels (<50V)

Source: Parker 514C DC Controller Technical Manual

All Parker 514C documents by type

Service Manual 1

Disassembly, diagnostics and part numbers, for repair.

User Manual 2

Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.

Questions answered in these manuals

What type of motors can the 514C controller drive?

The equipment is intended for industrial motor speed control using DC shunt wound or DC permanent magnet motors.

From: Parker 514C DC Controller Technical Manual

What mains supply does the 514C require?

It operates from a single phase AC mains supply of 110 Vac to 415 Vac at 50 or 60 Hz.

From: Parker 514C DC Controller Technical Manual

How long should I wait for the drive's capacitors to discharge before working on the equipment?

Allow at least 5 minutes for the drive's capacitors to discharge to safe voltage levels (<50V), and confirm with a meter capable of measuring up to 1000V dc & ac rms.

From: Parker 514C DC Controller Product Manual

What type of meter should be used for measurements on the 514C?

Use only a meter to IEC 61010 (CAT III or higher), always starting with the highest range; CAT I and CAT II meters must not be used.

From: Parker 514C DC Controller Product Manual

What personnel are required to install and service the equipment?

Installation, operation and maintenance should be carried out by qualified personnel who are technically competent and familiar with all safety information.

From: Parker 514C DC Controller Technical Manual

What safety precautions are required before working on the equipment?

All incoming supplies must be isolated before working on the equipment, and the equipment must be permanently earthed.

From: Parker 514C DC Controller Technical Manual