Delta ASDA-A2 Servo Drive User Manual

Delta ASDA-A2 Series Servo Drive User Manual covering installation, wiring, trial operation, tuning, control functions, parameters, communication, and…


Delta ASDA-A2 Servo Drive User Manual - cover page
Brand
Delta
Category
Automation control Equipment
Document type
User Manual
Language
Chinese
Pages
751
File format
PDF
File size
28.9 MB
Published
17 November, 2026
Updated
17 November, 2026
Model
ASDA-A2
MD5 checksum
9E3F3B0D169D2DBE23F4AE45C111FDCE

About this manual

This user manual covers the Delta ASDA-A2 series servo drives and ECMA series servo motors. It includes installation and inspection, component descriptions, trial operation procedures, control functions and tuning methods, parameter descriptions, communication protocols, inspection and maintenance, and troubleshooting. It is intended for servo system designers, installation and wiring personnel, trial-run tuning personnel, and maintenance or inspection personnel.

The manual states that the ASDA-A2 series is an open-type servo drive that must be installed in an enclosed control box during operation. It uses a digital signal processor (DSP) to control IGBT current output and drive a three-phase permanent magnet synchronous AC servo motor (PMSM) for positioning. This manual is written in Chinese.

What's inside

  • Product inspection and model description
  • Installation
  • Wiring
  • Panel display and operation
  • Trial operation and tuning
  • Control functions
  • Parameter descriptions
  • Communication protocol
  • Inspection and maintenance
  • Troubleshooting

Specifications

Grounding systemClass-3 (100 Ω or less)
Signal input cable lengthMaximum 3 m (9.84 in)
Feedback cable lengthMaximum 20 m (65.62 ft)
Power and signal cable separationAt least 30 cm (11.8 in)
Power cycling intervalNo more than once per minute
Motor typeThree-phase permanent magnet synchronous AC servo motor (PMSM)

Frequently asked questions

What grounding system should the ASDA-A2 be connected to?

It should be connected to a class-3 grounding system with 100 Ω or less.

Can three-phase power be connected to the motor U, V, W terminals?

No. The manual prohibits connecting three-phase power to the motor U, V, W terminals because it will damage the servo motor.

How long should I wait after turning off power before touching the terminals?

Do not touch the terminals within 10 minutes after power is turned off; residual voltage may cause electric shock.

What is the maximum encoder feedback cable length?

The feedback cable can be up to 20 m (65.62 ft) long.

Download PDF (28.9 MB)

More Delta Manuals


View all Delta manuals →