3M Instruction Bulletin 5.78 explains application of Controltac conformable reflective film, including surface prep, tools, heat use, and lifting prevention.
This bulletin is Instruction Bulletin 5.78 Release A for applying 3M Graphic Film Controltac conformable reflective film. It says the film must be post-heated after installation to prevent lifting and lists surfaces where the film should not be applied.
It covers recommended films, how reflective films work, application tools and cleaning products. It also gives surface preparation steps, best application temperature, and methods for reducing film lifting, including Primer 94 and post-application heat.
| Recommended film | 3M Scotchlite Print Wrap Film 780mC-10R |
|---|---|
| Adhesive | Pressure-activated; slideable, positionable and repositionable until application pressure is applied |
| Angularity | Higher retroreflective brightness when viewed at angles greater than 45 degrees |
| Primer application window | Apply the film within 1 hour after the primer dries |
The bulletin says not to apply the film to low surface energy plastics, weather stripping rubber, stainless steel or textured plastic substrates.
Post-heating is required to prevent lifting.
The bulletin lists 3M Scotchlite Print Wrap Film 780mC-10R as a recommended film.
The final cleaning agent is a 70/30 mixture of isopropyl alcohol and water.