This document is an instruction manual for SONY's MDR-EX51LP earphones. It introduces information on how to use, install and clean the earphones.
This two-page Operating Instructions document covers the Sony MDR-EX51LP stereo earphones. It lists the earphones' specifications, including the 9 mm CCAW dome driver units, 16 ohm impedance, 100 dB/mW sensitivity, and 6 – 23,000 Hz frequency response, together with the supplied earbuds in sizes S, M, and L and the cord holder.
The guide explains how to wear the earpieces (marked R for the right ear and L for the left), how to use the holder to prevent tangling and adjust cord length, how to install the earbuds correctly for better low-bass sound, how to clean the earbuds, and precautions about keeping them clean and avoiding high-volume listening while driving or cycling.
| Type | Closed, dynamic |
|---|---|
| Driver units | 9 mm (CCAW adopted), dome type |
| Power handling capacity | 100 mW (IEC) |
| Impedance | 16 ohms at 1 kHz |
| Sensitivity | 100 dB/mW |
| Frequency response | 6 – 23,000 Hz |
| Cord | Approx. 1.2 m (47 1/4 in.), OFC litz cord |
| Plug | Gold-plated stereo mini plug |
| Mass | Approx. 4 g (0.14 oz.) without cord |
| Supplied accessories | Earbuds (S x 2, M x 2, L x 2), Holder (1) |
Wear the earpiece marked R in your right ear and the one marked L in your left ear.
Earbuds are supplied in three sizes: S x 2, M x 2, and L x 2, plus one holder.
Remove the earbuds from the earphones and wash them with a mild detergent solution.
It prevents the cord from becoming tangled when stored, and you can wind the cord around it to adjust the cord length.