This article describes the Spanning Tree Protocols (STP, RSTP, and MSTP) supported by AlliedWare Plus™ products and how to configure them on these products.
This guide explains how to configure Spanning Tree Protocol (STP), Rapid Spanning Tree Protocol (RSTP), and Multiple Spanning Tree Protocol (MSTP) on AlliedTelesis switches. It covers the operation, modes, and configuration steps for each protocol. The guide applies to AlliedWare Plus products running version 5.4.4 or later, with support varying by device. Configuration commands are detailed in the switch’s Command Reference on alliedtelesis.com.
The protocols prevent broadcast storms by creating a loop-free topology using Bridge Protocol Data Units (BPDUs). STP is the original IEEE 802.1D protocol, RSTP (IEEE 802.1D-2004) converges faster, and MSTP (IEEE 802.1Q-2005) supports multiple VLANs and regions. Devices can auto-detect connected device modes or be forced to a specific mode using the spanning-tree force-version command.
This guide applies to AlliedWare Plus products running version 5.4.4 or later.
Configuration procedures are detailed in the guide, with commands referenced in the switch’s Command Reference on alliedtelesis.com.
By default, the device operates in RSTP mode.