This manual describes the functions of CANopen protocol in CFW-08 inverter.
This document provides instructions for operating the WEG CFW-08 frequency inverter within a CANopen network. It details the requirements for using the specific CANopen communication kit (KFB-CO-CFW-08) which must be installed on the control card version A3.
The guide covers the introduction to the CANopen protocol, physical installation steps including connector and termination resistor setup, and configuration of new parameters such as controller status and lost telegram counters. It also defines variables for communication state and speed commands. This manual is written in Portuguese.
| Communication Kit Code | 417118221 |
|---|---|
| Protocol Standard | CAN Specification 2.0 |
The kit code is 417118221.
The inverter must have a control card with the 'A3' version code installed.
Serial communication protocols, specifically WEG, Modbus-RTU, and remote IHM serial.
A data field can contain up to 8 bytes of data.