Alarm code4837
The OVERRUN SINGNEAL ERROR (OT2) indicates an unmatched enable signal or connection failure. The manual's first action is: “(1)Reset the alarm. (2)If the alarm occurs again, confirm the followings. - Select "OVERRUN & S-SENSOR"from "ROBOT" menu to display OVERRUN & S-SENSOR window. The alarm can be released on this window.”
- Model
- Yaskawa FS100
- Display shows
- OVERRUN SINGNEAL ERROR (OT2) (4837)
- Type
- Alarm code
- Source
- Manual p. 297
What 4837 means
OVERRUN SINGNEAL ERROR (OT2) p. 297
Common causes
What to do
- (1)Reset the alarm. (2)If the alarm occurs again, confirm the followings. - Select "OVERRUN & S-SENSOR"from "ROBOT" menu to display OVERRUN & S-SENSOR window. The alarm can be released on this window. p. 297
- (1)Reset the alarm. (2)If the alarm occurs again, confirm the following. - Replacement of the connection cable p. 297
- (1)Reset the alarm. (2)If the alarm occurs after the replacement of the machine safety module, execute the following operation. - Replacement of the limit switch or corresponding parts. p. 297
Before you service the product, read the safety instructions in the manual p. 4.
If 4837 is still not resolved
- (1)Reset the alarm. (2)If the alarm occurs again, confirm the followings. - Select "OVERRUN & S-SENSOR"from "ROBOT" menu to display OVERRUN & S-SENSOR window. The alarm can be released on this window. p. 297 “(1)Reset the alarm. (2)If the alarm occurs again, confirm the followings. - Select "OVERRUN & S-SENSOR"from "ROBOT" menu to display OVERRUN & S-SENSOR window. The alarm can be released on this window.”
This page summarises what the manufacturer’s manual says about 4837; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.