Yaskawa FS100 Error 4941: CANNOT EXECUTE MOTION CMD (SV)

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code4941

The system cannot execute a motion command due to a software operation error. The manual's first action is: “(1)Reset the alarm. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”

Model
Yaskawa FS100
Display shows
CANNOT EXECUTE MOTION CMD (SV) (4941)
Type
Alarm code
Source
Manual p. 300

What 4941 means

CANNOT EXECUTE MOTION CMD (SV) p. 300

Common causes

  • Software operation error occurred p. 300

What to do

  1. (1)Reset the alarm. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 300

If 4941 is still not resolved

  • (1)Reset the alarm. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 300
    “(1)Reset the alarm. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
Open the manual at page 300 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 4941; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.