Alarm code4655
The system attempted to read a register that does not exist. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
- Model
- Yaskawa FS100
- Display shows
- WRONG EXECUTION OF GETREG INST (4655)
- Type
- Alarm code
- Source
- Manual p. 280
What 4655 means
WRONG EXECUTION OF GETREG INST p. 280
Common causes
- An attempt was made to acquire the value of the register not existing. p. 280
What to do
- (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 280
If 4655 is still not resolved
- (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 280 “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
This page summarises what the manufacturer’s manual says about 4655; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.