The SETREG instruction attempted to change a register value currently in use by TMR/CNT. The manual's first action is: “(1)Check the following settings. - The SETREG instruction cannot change the register values used in TMR/CNT. Correct the setting of tag that specifies register number of SETREG instruction.”
- Model
- Yaskawa FS100
- Display shows
- WRONG EXECUTION OF SETREG INST (4654)
- Type
- Alarm code
- Source
- Manual p. 280
What 4654 means
WRONG EXECUTION OF SETREG INST p. 280
Common causes
- An attempt was made to change the value of the register currently used by TMR/CNT. p. 280
What to do
- (1)Check the following settings. - The SETREG instruction cannot change the register values used in TMR/CNT. Correct the setting of tag that specifies register number of SETREG instruction. p. 280
If 4654 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Yaskawa service.
This page summarises what the manufacturer’s manual says about 4654; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.