Yaskawa FS100 Error 4052: MEMORY ERROR (TOOL IN TERFEREN CE)

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code4052

MEMORY ERROR (TOOL IN TERFEREN CE) indicates data or CPU board failure causing tool interference issues. The manual's first action is: “(1)Reset the alarm. (2)If the alarm occurs again, initialize the tool interference file in maintenance mode, and then load the tool interference file saved in the external memory device.”

Model
Yaskawa FS100
Display shows
MEMORY ERROR (TOOL IN TERFEREN CE) (4052)
Type
Alarm code
Source
Manual p. 158

What 4052 means

MEMORY ERROR (TOOL IN TERFEREN CE) p. 158

Common causes

What to do

  1. (1)Reset the alarm. (2)If the alarm occurs again, initialize the tool interference file in maintenance mode, and then load the tool interference file saved in the external memory device. p. 158
  2. (1)Reset the alarm. (2)If the alarm occurs again, replace controller. Save the CMOS.BIN before replace controller to be safe. p. 158

If 4052 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Yaskawa service.

Open the manual at page 158 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 4052; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.